Fujitsu-siemens-computers Tablet DOCK ST5100 Series User Manual download pdf (Page 8)

Stylistic ST Series Tablet Dock

LOADING MEDIA

(Refer to Figure 8 for the following steps)

To load a disc into your optical drive, follow these steps:

1. Push and release the eject button on the front of the

drive to open the holder tray. The tray will come out

of the system a short distance.

2. Gently pull the tray out until a media disc can easily

be placed in the tray

3. Place the media into the tray, label side up, with the

hole in the center of the disc. Snap the disc onto the

raised circle in the center of the tray.

4. Push the holder tray back in until you hear a click.

REMOVING MEDIA

(Refer to Figure 8 for the following steps)

1. Push and release the eject button on the front of the

optical drive. This will stop the drive and the holder

tray will come out of the system a short distance.

2. Gently pull the tray out until the disc can easily be

removed from the tray.

3. Remove the media disc from the holder tray.

4. Push the holder tray back in until you hear a click.

EMERGENCY TRAY RELEASE

You may encounter a situation in which you need to

open the media tray when power is not applied to the

dock. To open the tray when power is not applied, insert

an opened paper clip into the emergency tray release slot

located next to the eject button. (See figure 1 on page 2

for location). When the paper clip is inserted far enough,

the tray will open.

Figure 8. Loading/Ejecting Media

■

You should periodically check the Fujitsu

website at us.fujitsu.com/computers for

updated drivers.

■

All Fujitsu DVD players are set to play

DVD titles with region code number 1

(North American market). The region

number is a regional restriction code

defined by the DVD Forum acting on

requirements of Hollywood. Different

region codes are recorded on video DVD

titles for publication in different areas of

the world. If the regional code of the

DVD player does not match the codes on

the titles, then playback is impossible.

You can change the region code on the

DVD player using the Properties menu of

the DVD software, but you can only

change the region code up to four times.

After the 4th change, the last region

code entered becomes permanent, and

cannot be changed.

There may be a protective sheet in the tray

from when it was shipped; make sure it is

removed before operating the drive.

Tablet Dock.book Page 6 Wednesday, October 18, 2006 1:59 PM

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Fujitsu-siemens-computers Tablet DOCK ST5100 Series User Manual Page 8

Comments to this Manuals

Related products and manuals for Laptops Fujitsu-siemens-computers Tablet DOCK ST5100 Series